Parts
No parts specified.
-
-
Turn the power off to the module.
-
Remove the 8 screws that hold the top panel in place, and remove the top panel.
-
-
-
Examine the power switch terminal blocks for any sign of looseness, as shown in the photo.
-
To tighten the screw that holds these blocks together, it may be necessary to bend the pressure relief valve housing out of the way, as shown in the second two photos.
-
-
-
Locate the terminal block mounting screw, on the back of the block furthest away from the switch. Using a flat screw driver, tighten this screw.
-
-
-
Ensure that both screws holding the power switch bracket to the front panel are tight. These screws can be tightened using a flat screwdriver. The side panel will need to be removed to access the bottom screw.
-
Replace all panels, and connect the module's power cord to the power supply.
-
Verify that switch is operating correctly. If you are still having problems, please contact Modbar support.
-